How To Repair A Jalousie Window Crank

Introduction

Jalousie windows are a mainstay in older mobile homes. Replacing windows is expensive, so I'm replacing my not-functional gearboxes with new units. In most cases, replacing the gearbox will enable the window to crank fully open up and airtight again. Information technology'south simple in theory, the hardest office is maneuvering in the limited space to replace i, but I'll show you how to go it done!

• Before you begin, crank the window open an inch or ii.

• After the crank is removed, you won't be able to open the window for extra room to use your screwdriver in here.



• To become to the gearbox, you must remove a few parts.

• Remove the crank handle screw.

• Remove the crank handle by pulling it straight out.

• Discover in the picture that the window frame is still in front of the gearbox. You volition demand to either remove that side of the frame or shift it out of the fashion.

• Using a Phillips screwdriver, remove the two screws from the gearbox.

• Using a Phillips screwdriver, remove the two screws from the mount at the opposite end of the bar.

• Lift the bar upward slightly so that it pivots and the gearbox volition scroll well-nigh 30 degrees back.

• This allows you to clear the lower window frame and pull the bar clear of it.

• Angle the bar every bit y'all're bringing it forward then that the gearbox clears the frame get-go, and then the mount side tin exist brought forward too.

• Pry the gearbox from the finish of the bar using a flat head screwdriver.

• If it seems stuck, piece of work the screwdriver effectually the gap gently. You don't want to curve anything.

• Place the new gearbox onto the cease of the bar. Be certain to line upwardly the slots in the bar with the two ridges inside the sleeve of the gearbox.

• You lot do not demand to remove the mountain on the other cease unless it is cleaved and also needs to be replaced. Both of these parts need to be deeply fastened to the window box for the window to work.

• With the new gearbox in identify, angle the bar dorsum into place with the mount terminate going in first. .

• Proceed the bar slightly rotated and then that the gearbox will clear the window frame.

• The gearbox angle you see in the picture is important.

• Swing the gearbox and the mount into their original positions, matching the screw holes is a good reference.

• Reinstall the screws in the gearbox and mountain.

• After you have screwed the gearbox and mount into place, test the gearbox with the crank to be sure it opens and closes.

• If everything functions well, put your frame and creepo handle back on.

Determination

Mission achieved!

Team

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview

Source: https://www.ifixit.com/Guide/Jalousie+Window+Gearbox+Replacement/103914

Posted by: morrisonsest1991.blogspot.com

Share this post